Arofanatics Fish Talk Forums  

Go Back   Arofanatics Fish Talk Forums > General Aquatic Forums > Freshwater Invertebrates Forum

Reply
 
Thread Tools Display Modes
Old 04-03-2010, 02:42 AM   #1
spiderman_123
Arofanatic
 
Join Date: Aug 2008
Posts: 86
Default sudden breakdown Hailea chiller HC-150

hi all bros,

my hailea chiller temp from 24degree keep go up till 32plus, and touch surface hot.try to unplug and plug in power cord then re-start chiller,still no use.got sound but seems no air draw in when use hand to touch the front surface.

like to ask any bros out there using hailea chiller got encounter same problem as mine before? is it the fan or motor failure?
any bros out there knows the cost of repair and where?hope not more than 100plus. tq
spiderman_123 is offline   Reply With Quote
Old 04-03-2010, 10:30 AM   #2
Sianzation
Dragon
 
Sianzation's Avatar
 
Join Date: Jan 2008
Posts: 618
Default

normally for china chiller, the 1st to spoilt will be the thermostat.

maybe an external thermostat can solve your problem. What you need to do is to disconnect the power cable to the controller and use the external thermostat controller to programe.

firstly, when you power on the chiller now, does the controller show the correct temperature?

if it shows a very high or very low temp, this will confirm that your thermostat is spoilt.
Sianzation is offline   Reply With Quote
Old 05-03-2010, 01:57 AM   #3
spiderman_123
Arofanatic
 
Join Date: Aug 2008
Posts: 86
Default

Quote:
Originally Posted by Sianzation View Post
normally for china chiller, the 1st to spoilt will be the thermostat.

maybe an external thermostat can solve your problem. What you need to do is to disconnect the power cable to the controller and use the external thermostat controller to programe.

firstly, when you power on the chiller now, does the controller show the correct temperature?

if it shows a very high or very low temp, this will confirm that your thermostat is spoilt.
thanks bro. last nite i power on it shows 32degree.set 28degree,but it nv comes down.thermometer in my tank shows ard 30degree also. does this tell the thermostat okay? can it be fan or motor? cause scare go buy thermostat(quite expensive)and end up okay.
spiderman_123 is offline   Reply With Quote
Old 05-03-2010, 02:00 AM   #4
spiderman_123
Arofanatic
 
Join Date: Aug 2008
Posts: 86
Default

any bros

wonder how high temp can a chiller goes?cause my chiller goes uo to 32.4 degree instead of goes to 28 degree temp i set.
spiderman_123 is offline   Reply With Quote
Old 05-03-2010, 03:00 PM   #5
monster_88
Guest
 
Posts: n/a
Default

You may want to check that your pump is pumping sufficiently, as the chiller will run continuously and heats up when the pump is not pumping sufficiently. I had a previous bad experience when my pump failed and the chiller heats up but the tank water does not get chilled. (By the way, what pump are you using? Does it match the required flowrate of the chiller?)
As for the fan, I believe you should be able to either hear the motor sound (basically the main component in the chiller that creates noise) or if open the air filter cover you may be able to see the fan/feel the airflow.
Hope it helps. Good luck.
  Reply With Quote
Old 06-03-2010, 02:06 AM   #6
spiderman_123
Arofanatic
 
Join Date: Aug 2008
Posts: 86
Default

Quote:
Originally Posted by monster_88 View Post
You may want to check that your pump is pumping sufficiently, as the chiller will run continuously and heats up when the pump is not pumping sufficiently. I had a previous bad experience when my pump failed and the chiller heats up but the tank water does not get chilled. (By the way, what pump are you using? Does it match the required flowrate of the chiller?)
As for the fan, I believe you should be able to either hear the motor sound (basically the main component in the chiller that creates noise) or if open the air filter cover you may be able to see the fan/feel the airflow.
Hope it helps. Good luck.
thanks bro.i got open the air filter but unable see the fan as been block by coil.no hear motor sound when set lower temp like previously when coolin down.i use eheim 2028.but only 1.5ft tank.water outlet ok even now after i off the power of chiller.
spiderman_123 is offline   Reply With Quote
Old 07-03-2010, 11:45 PM   #7
numbskull
Arofanatic
 
Join Date: Jan 2009
Posts: 422
Default

Hi bro. I'm not surprised. I'm using hailea 150 too. My chiller same like yours as well just breakdown 1 week ago. Set at 25 and woke up suddenly my chiller can't cool it down. Can hear the motor and pump running for 5 mins then suddenly it stops running but still can hear like running water through the chiller. Then the running will stop after 5 to 10mins and whole process will trigger after 5 mins of cooldown. During the running my chiller feels hot as well. This happens exactly after 6 months of warranty. Gonna call Aquaspans and let's see what they quote me. Remember the guy is call David. Will post here and let TS knows the costs. Gonna be the last time buying a china brand chiller.
numbskull is offline   Reply With Quote
Old 04-03-2010, 05:02 PM   #8
icebabys
Guest
 
Posts: n/a
Default

how long have you been using the chiller? think some bros here mention that there are some ppl who can service the chiller.... do a search... u can find their contacts.
  Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +9. The time now is 02:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright © 2000-2008 Arofanatics.com (Since 30th August 2000)